Heat Exchangers FHC060 Exporters

Inlet valve, and then slowly open the outlet valve of cold and hot medium at the same time. When the pressure difference between the front and rear of the filter is large, the filter can be disassembled for cleaning. Cleaning the filter too frequently can also cause the stainless steel plate heat exchanger to fail due to blockage of the plate passages.

Filter cleaning of plate heat exchanger In order to reduce the frequency of maintenance and cleaning of the titanium plate heat exchanger, a coarse filter is generally installed on the inlet pipeline of the cold and heat medium to prevent 3 to 5 mm particles from blocking the plate passage.When the titanium plate heat exchanger is put into use for the first time, in order to avoid the leakage of the plate heat exchanger caused by excessive pressure fluctuations, the cold and hot medium water inlet valve must be opened slightly Heat Exchangers FHC060 Exporters at the same time, and the pressure in the heat exchanger is slowly increased until it is fully opened. Blindly opening and closing water inlet and outlet valves or medium pressure fluctuations caused by other reasons may cause leakage of the stainless steel plate heat exchanger

 In order to meet market demand, unify the order and improve the standard, this revision adds TA9 Tihe## to this standard.. But this standard only stipulates the various technical requirements of TA1-A, and now the market uses TA8-1 and TA9-1 grades of titanium alloy plate heat exchanger materials more and more, and TA8-1 and There is no standard for TA9-1 titanium alloy heat exchanger plates. The fluid flow rate, physical properties, pressure drop and temperature difference determine the number and size of the plates

In the work of the plate heat exchanger, the working environment is very complicated. For example, using a good plate heat exchanger material will improve the heat exchange efficiency  of the heat exchanger, so the value of the heat exchanger itself is also Be reflected. Good materials are more resistant to corrosion, which can not only reduce material loss, but also avoid the time wasted when the plate heat exchanger is repaired. Therefore, we must make a selection when selecting materials

 

Megosztás a facebookon